Support The Forums:
The forums have been hosted for some time now out of my pocket. We are coming up on the annual domain renewal for ohioccwforums.org and I pay roughly $20/month to keep the forums online. I do this to maintain the long-standing history of discussions here indexed in Google, and so that people have a place to discuss this topic outside of modern social media censorship. If you enjoy the forums and you'd like to help offset the cost, please consider a venmo donation hereCZ 82/83 experts needed
Moderators: Chuck, Mustang380gal, Coordinators, Moderators
-
yogidave
- Posts: 1929
- Joined: Sat Jan 17, 2009 9:23 am
- Location: maumee
Re: CZ 82/83 experts needed
Yes it works, I think I found out what the probelm was. The slide had a rough edge that was catching, I filed it down and polished it. After that I ran some dummy rounds through and it seemed to fix it. Have to do a test fire and will update.
-
Dewman
- Posts: 189
- Joined: Fri Mar 23, 2012 4:14 pm
- Location: Hamilton,Ohio
Re: CZ 82/83 experts needed
Sweet . Hope it works
Allways remember when in combat your weapon was made by the lowest bidder
-
yogidave
- Posts: 1929
- Joined: Sat Jan 17, 2009 9:23 am
- Location: maumee
Re: CZ 82/83 experts needed
Ok so test fire and same issue, after 2 boxes of ammo, a tank of gas from making multiple trips to the range and a lot of swearing I now know what the problem is. The spring in the slide release is either weak or broke. As the slide came back the slide release would pop up and catch the slide. I held the slide release down with my thumb (awkward BTW) and fired a full magazine without an issue. I ended up shooting 3 mags while doing this and it functioned flawlessly, its a $7 part and I ordered it today. This was about to be the most expensive duck decoy anchor if I didn't figure it out.
-
CCIman
- Posts: 1823
- Joined: Mon Nov 17, 2008 11:12 pm
- Location: SW Ohio
Re: CZ 82/83 experts needed
You never mentioned that the slide was locking back specifically, but it seemed you were describing FRTB or FTF.
Glad you found the problem.
Glad you found the problem.
'CAN' does not equal "SHOULD'.
-
Dewman
- Posts: 189
- Joined: Fri Mar 23, 2012 4:14 pm
- Location: Hamilton,Ohio
Re: CZ 82/83 experts needed
I need to find the diagram I used for mine. That spring can be a pain to put back in.
The roll pin holds it down.
There should be a small hole under the roll pin that the spring goes into and then the roll pin is driven overtop of to hold it down. If they followed the CZ82 method then it was put in wrong. Two different springs. I had to buy a set of surgical clamps to do the job.
The roll pin holds it down.
There should be a small hole under the roll pin that the spring goes into and then the roll pin is driven overtop of to hold it down. If they followed the CZ82 method then it was put in wrong. Two different springs. I had to buy a set of surgical clamps to do the job.
Allways remember when in combat your weapon was made by the lowest bidder