Comparing plated rounds manufacturers

To learn and introduce new loaders. Tips and tricks from old timers.

Moderators: Coordinators, Moderators

Comparing plated rounds manufacturers

Postby Morne » Tue Dec 20, 2016 12:05 pm

Fellow Reloaders,

So, I am almost out of my X-Treme 230-gr CPRN bullets for .45 ACP. I have a BUNCH of Rainer 230-gr slugs laying around, though.

The question is, "Can I use load data that I generated with X-Treme copper plated bullets for other manufacturer's copper plated bullets?"

I know X-Treme has thicker copper plating than most of the other brands. Is Rainier comparable? Both seem to indicate that you can use jacketed data.

How about Berry's?

Or should I, just to be safe, make up the original load ladder with that cartridge/primer/powder/bullet combo again and re-chrono everything? :?:
Thus spoke Zarathustra.

Footsoldier in the Conservative Insurrection of the GOP.

Remember, only you can prevent big government!
User avatar
Morne
OFCC Director
OFCC Director
 
Posts: 10450
Joined: Thu Jul 07, 2005 9:01 pm
Location: Wayne County

Re: Comparing plated rounds manufacturers

Postby WY_Not » Tue Dec 20, 2016 1:07 pm

Reloading, like pressure canning, is one of those things where I'd rather ere on the side of caution. Personally, I'd lower the powder charge and work back up. Might wind up with the same load or might find a combo that works better with the new bullets.
Learn how Project Appleseed is supporting freedom through Marksmanship and Heritage clinics.

Samuel Adams wrote:If ye love wealth better than liberty, the tranquility of servitude better than the animating contest of freedom, go home from us in peace. We ask not your counsels or your arms. Crouch down and lick the hands which feed you. May your chains set lightly upon you, and may posterity forget that you were our countrymen.
User avatar
WY_Not
OFCC Patron Member
OFCC Patron Member
 
Posts: 2108
Joined: Wed May 02, 2007 10:15 pm
Location: Miami County, OH

Re: Comparing plated rounds manufacturers

Postby Sevens » Tue Dec 20, 2016 4:11 pm

^BIG TIME

The easiest answer is that it's very hard to find published load data for plated in the first place simply because plated acts differently, and you can bet for sure that different plated acts differently.

At my bench, where I simply do NOT run maximum loads with plated... I don't start back at the bottom typically, but I have also loaded 100k+ of plated and have some comfort level that you may not yet have.

In my experience, Berry's makes a fantastic bullet and Xtreme is nearly as good (Xtreme is prettier!) All of the others line up behind these two. But all of them have the potential to act differently.

Your ammo is worth more than cheap shortcuts, unless you simply don't need the level of performance/confidence in those particular loads. And that was not meant to be a smart-aleck comment, I'm referring to, say, cowboy action loads that don't typically demand a lot of "performance" in most ways we might measure.
I like to swap brass... and I'm looking for .32 H&R Mag, .327 Fed Mag, .380 Auto and 10mm. If you have some and would like to swap for something else, send me a note!
User avatar
Sevens
OFCC Patron Member
OFCC Patron Member
 
Posts: 7392
Joined: Thu May 07, 2009 8:30 am
Location: Far East Side of CBus


Return to Handloading

Who is online

Users browsing this forum: No registered users and 2 guests