small rifle primer compatability

To learn and introduce new loaders. Tips and tricks from old timers.

Moderators: Coordinators, Moderators

small rifle primer compatability

Postby Greenleaf4902 » Sun Dec 11, 2016 9:57 am

I use CCI 400 small rifle primers for the 25/20 and have been given many boxes of federal 200 small rifle primers. Are they compatable? I mean like the CCI 200 and the CCI 250 and the Remington 9-1/2 and the federal 210 ?????
Greenleaf4902
 
Posts: 43
Joined: Thu Nov 24, 2016 8:54 am
Location: Ashland Richland and Other Counties

Re: small rifle primer compatability

Postby evan price » Sun Dec 11, 2016 12:12 pm

Should be fine, but, as always.... "whenever you change a component start with a reduced charge and work back up."
"20% accurate as usual, Morty."

Striking down evil with the mighty sword of teamwork and the hammer of not bickering!
Carpe Noctem- we get more done after 2 am than most people do all day.
User avatar
evan price
Forum Janitor
Forum Janitor
 
Posts: 8834
Joined: Sun Jul 02, 2006 9:23 pm
Location: Westfield, Ohio

Re: small rifle primer compatability

Postby Sevens » Sun Dec 11, 2016 12:33 pm

Absolutely and completely compatible. When selecting primers, you are first looking for two things -- physical size fit and max pressure ability. Both are important. Physical size matters so that the loaded round will chamber and the typical hammer fall will ignite the primer. The ability to handle the pressure means an awful lot so that when the round is doing as designed, the primer is not a weak link that leads to leaked pressure.

If your load data is showing examples with a small rifle primer... then you are fine to use ANY small rifle primer, keeping in mind precisely what Evan Price said above. Each/any load can or will act differently with a change of primer.

It's a myth in handloading that published data is a strict line-by-line recipe. It is NOT. Published load data is an example with published test results. If you use every little nuance of published data, you might "expect" similar results. But to be clear, you REALLY have to follow that data! You can't simply use the same primer, powder, bullet, etc etc. If you truly wish to copy their results, you will also need their barrel length, their ambient temperature, their position above sea level, etc etc.

The point is that it's not a strict recipe. They are publishing their test results and you look at those test results and they guide you toward developing your loads. So you pick the primer (as long as it's appropriate) and you start with a lower charge weight than published max and you get to work on load development.
I like to swap brass... and I'm looking for .32 H&R Mag, .327 Fed Mag, .380 Auto and 10mm. If you have some and would like to swap for something else, send me a note!
User avatar
Sevens
OFCC Patron Member
OFCC Patron Member
 
Posts: 7384
Joined: Thu May 07, 2009 8:30 am
Location: Far East Side of CBus


Return to Handloading

Who is online

Users browsing this forum: No registered users and 1 guest